Parametric fan remote holder

Parametric fan remote holder, customize it to fit your fan and remote! The most important dimensions you can change:Fan Tube Width → Measure the diameter of your fan tube and enter it in mm's. RemoteWidth → How wide your remote is RemoteLength → Not the “height” of the remote, but how ‘deep’ it is, make sure you account for the buttons sticking out of the front side RemoteHeight → How tall you want the remote holder to be, I used half of my remote height Additional parameters: RemoteToTubeDistance → How far the edge of the remote holder is from the fan tube, so it doesn't interfere with any plastics below the tube RemoteOpeningLipWidth → How wide the side lip on the front side of the remote holder is, make sure it's atleast 1-2mm minimum so the overhangs print better ClampOpeningSideDistance → How “big” the clamping of the circle will be, bigger number → bigger circle, might be harder to snap ClampHeight → Just the height of the clamping part ClampTightnessTolerance → Toler