Parametric Gridfinity Electronic Component Holder

This is an an upgrade to my other model for Gridifnity(https://gridfinity.xyz/) Breadboards (https://makerworld.com/en/models/1718223-gridfinity-electronic-component-storage-arduino#profileId-1823774). This fixes a few issues, such as it not fitting on some grids, needing supports, etc. Also added the ability to tailor it to any height, size with magnets, etc. So with the parametric model, you can add lips, etc. The original bins were similar to https://makerworld.com/en/models/234549-gridfinity-esp32-1x2-bin?from=search#profileId-493143, which uses square holes, I used round positioning into the square holes, which help with bent pins.. This is standard industry component spacing of 2.54mm on center, and I used 0.9 mm holes. Based on the Gridfinity spec, a 1U space is 7mm, I added a second layer to match the hole depth. So a minimum height is about 2U. If you have walls less than 2U, you get a flat surface. Also this time I don't go into the base. Also check out this storage solut