Thingiverse
Parametric Icicles
por larsrc
2
Descargas
4
Likes
0
Makes
HELP WANTED!
These are there different approaches to making parametric icicles, increasingly realistic. But they
V1 just makes a column with varying width (Brownina), but fully symmetric. It does not work in the current OpenSCAD.
V2 adds a bit of sideways distortion. It does not work with the current OpenSCAD, but I have an STL from it - there was some dimension error in it that I had to fix in other ways.
V3 does a fractal perturbation of the spine and some perturbation of each ring. I find this quite good. However, it does not quite work, it comes out as a non-closed mesh and has to be repaired to print, possibly for the same reason as V2. I am baffled why!
Printing is trivial, except it tends towards stringing a lot. Ironically apply heat to get better icicles. The picture shows a print of the one surviving STL.
There is a bunch of parameters, but until the mesh problems are fixed, it doesn't make sense as a Customizer.
Further ideas:
- Making the base follow a cu
These are there different approaches to making parametric icicles, increasingly realistic. But they
V1 just makes a column with varying width (Brownina), but fully symmetric. It does not work in the current OpenSCAD.
V2 adds a bit of sideways distortion. It does not work with the current OpenSCAD, but I have an STL from it - there was some dimension error in it that I had to fix in other ways.
V3 does a fractal perturbation of the spine and some perturbation of each ring. I find this quite good. However, it does not quite work, it comes out as a non-closed mesh and has to be repaired to print, possibly for the same reason as V2. I am baffled why!
Printing is trivial, except it tends towards stringing a lot. Ironically apply heat to get better icicles. The picture shows a print of the one surviving STL.
There is a bunch of parameters, but until the mesh problems are fixed, it doesn't make sense as a Customizer.
Further ideas:
- Making the base follow a cu
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
