Parametric Key & Coin Catchall Tray

OverviewA simple, clean key/coin drop tray that’s fully parametric in MakerWorld. Dial in the exact size you need for an entryway table, bedside, desk, or workshop bench. The inside scoop makes it easier to grab coins and small items.Example size shown: 100 × 150 × 15 mm.Printing DetailsPrint difficulty: EasySupports: Not requiredOrientation: Print flat on the baseRecommended layer height: 0.12 mm (best finish on the inside scoop)Suggested settings (good defaults):Walls: 3Top/Bottom: 4–5 layersInfill: 10–15% (or more for a heavier feel)A brim is optional if you have any edge lift on large sizes.File Formats Included3MF (MakerWorld parametric customisation)F3D (Fusion 360 source for full editing)VariationsAdjust these parameters in MakerWorld:Length, width, heightBase depthWall widthCorner radiusInside scoop radiusBase filletAssemblyNo assembly required.