Thingiverse
Parametric Label Holder
von ctheroux
5
Downloads
5
Likes
0
Makes
This is a Parametric Label Holder that can be glued on drawers and so on. The
size of the labels is given in the openSCAD log.
Support material is not required, but brim is if printed upright which is
recommended. An infill of 20% is recommended.
This object's main web page is:
http://www.ctheroux.com/parametric-label-holder/.
This object was designed using openSCAD.
You can request the source files on the page listed above.
size of the labels is given in the openSCAD log.
Support material is not required, but brim is if printed upright which is
recommended. An infill of 20% is recommended.
This object's main web page is:
http://www.ctheroux.com/parametric-label-holder/.
This object was designed using openSCAD.
You can request the source files on the page listed above.
ctheroux veröffentlicht auch auf
406 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
