Thingiverse
Electronics
Go to Model
Parametric Raspberry Pi Stand
111
Downloads
67
Likes
0
Makes
I needed a stand to put my Raspberry Pi cases upright. Since I have several different RasPi versions with different cases, I needed a stand that I could parameterize.
There is three variables you can toy with:
Width: This is the width of the case that needs to fit within the brackets.
Length: This is the length of the bridge between the two feet. This plus twice the thickness is the overall length.
Thickness: The thickness of the brackets. Two times the thickness plus the length is the overall length of the print.
There is three variables you can toy with:
Width: This is the width of the case that needs to fit within the brackets.
Length: This is the length of the bridge between the two feet. This plus twice the thickness is the overall length.
Thickness: The thickness of the brackets. Two times the thickness plus the length is the overall length of the print.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
