Thingiverse
Electronics
Vai al Modello
Parametric Raspberry Pi Stand
111
Download
67
Likes
0
Makes
I needed a stand to put my Raspberry Pi cases upright. Since I have several different RasPi versions with different cases, I needed a stand that I could parameterize.
There is three variables you can toy with:
Width: This is the width of the case that needs to fit within the brackets.
Length: This is the length of the bridge between the two feet. This plus twice the thickness is the overall length.
Thickness: The thickness of the brackets. Two times the thickness plus the length is the overall length of the print.
There is three variables you can toy with:
Width: This is the width of the case that needs to fit within the brackets.
Length: This is the length of the bridge between the two feet. This plus twice the thickness is the overall length.
Thickness: The thickness of the brackets. Two times the thickness plus the length is the overall length of the print.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
