Thingiverse
Parametric Sponge Holder
von PetrHorn
1
Downloads
1
Likes
0
Makes
Paramatric Sponge Holder without the need of support.
In OpenSCAD the parameters can be adjusted for the size needed,
Then entering the STL file into Cura turn first 180 degrees in the Z axis and thereafter 45 degrees on the basis plate.
Or use SpongeHolderTurned file from the Meshmixer.
In OpenSCAD the parameters can be adjusted for the size needed,
Then entering the STL file into Cura turn first 180 degrees in the Z axis and thereafter 45 degrees on the basis plate.
Or use SpongeHolderTurned file from the Meshmixer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!