Thingiverse
Parametric Spool light storage
by 77nn
3
Downloads
1
Likes
0
Makes
[02 DEC 2020] Uploaded V1.
This is a parametric spool light storage. Basically it's a segmented halo that you can deploy around the spool groove, closing it for 360°. It is not airtight, but you can use some tape to achieve a certain degree. You can throw a few silica bags inside it to keep the moisture under control.
I included a pair of parametric spool hub caps as well, since some spools expose filament on that side as well.
It comes in 2 "print-in-place" sets of 3 segments each and it takes about 8 hours to print at a normal speed for a 1Kg spool. I tried to print it in 2 "print-in-place" segments only, but the overhangs fuse together and I threw everything away.
This is a parametric spool light storage. Basically it's a segmented halo that you can deploy around the spool groove, closing it for 360°. It is not airtight, but you can use some tape to achieve a certain degree. You can throw a few silica bags inside it to keep the moisture under control.
I included a pair of parametric spool hub caps as well, since some spools expose filament on that side as well.
It comes in 2 "print-in-place" sets of 3 segments each and it takes about 8 hours to print at a normal speed for a 1Kg spool. I tried to print it in 2 "print-in-place" segments only, but the overhangs fuse together and I threw everything away.
77nn also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
