Parametric Tuning Tower

A simple tool to create whatever tuning tower you need. Embedded into the design is an assumption that you will use 0.25 layer heights when printing, and you can do this with either individual layers or vase mode.

Just set your start number, step value, and number of stones to add to the tower.

Once sliced, you'll need to edit the GCODE manually in order to add in the change you're experimenting with. In the example tower added here, I'm changing the current used to drive the extruder motor using the Duet board. So, at each stone boundary, e.g. Z10.0, I'm adding in a separate line to alter the current; e.g.

M906 E1380:1380:1380:1380

https://duet3d.dozuki.com/Wiki/Gcode#Section_M906_Set_motor_currents

While the Duet has lots of flexibility, you could also just use this for plain temperature changes with M104.