Paramotor Strobe mount

This is a strobe mount designed around the DS-30 Led strobe (link below). It is designed to mount onto the upper safety net hoop of a paramotor using 3 heavy duty zip ties. The middle zip tie is dual purpose and also secures the 9V battery in place.

The bottom of the mount is curved to fit a 17mm round tube (if you want a flat bottom or something else, message me and I will whip something up for you)

There is a recessed area beside where the strobe sits to be able to route the wire. I am using a common 9V battery connector that has a 3mm diameter sheathing. there is a little bit of soldering required, use your common sense. There is not a lot of room in the recessed area so make your connections small and use some heatshrink to protect the wires.

I used hot glue to secure the strobe after finishing the wires.

No fancy on/off switch. just plug it in and go!


https://www.amazon.com/gp/product/B01CRAQ2CA/ref=oh_aui_detailpage_o02_s00?ie=UTF8&psc=1