Parfguide-storage 8x3

Description English (Deutsche Beschreibung siehe unten) I offer the hex-bit-storage in several variations: This version offers room for the Parfguide System Mk 2 bits and tools. Other variants are: 7 x 3 bits only 8 x 3 bits only 8 x 3 bits plus Wera Rapidaptor The backs fits on all french cleat systems which are at least 6mm strong.   Calibration (optional) Print the 1x1 scaling model at first an test the fit of your hex bits. Optimize the fitting to your needs by adjusting the scale factor in your slicer. If you have found the right scale factor that suits you, then apply it to all prints on all dimensions (including z) - even on the french cleat holder, so the width and the position of the screw holes stills fits to the hex bit storage . The z dimension needs also adjustment, so you still have a 45° angle for the french cleat!   Assembly Use two wood screws 3,0 x 10mm or 3,0 x 12mm to mount the pieces together. Be careful with the right screw! Because of the diameter of the drill guides I had to shorten the screw hole a bit. 10mm screws are fine. 12mm could be tight. Then hook the assembly to your french cleat wall.   Print instructions Material I printed with PLA, which absolutely hits all reqirements for my basement workshop.   Infill 10% infill is the minimum setting. The transition from the infill to the top solid layers is rather hard for the printer because of the many interruptions in the diagonal due to the hex bit holes. So the print needs several layers to recover a smooth surface. I recommend 15% infill. There are no difficulties to be expected.   Supports No supports needed!   Warping If you have trouble with warping I recommend "Micky Mouse Ears" on the four corners.   ================================================================   Deutsch Ich biete den Hex-Bit-Halter in verschiedenen Varianten an: Diese Variante bietet Platz für Parfguide System Mk 2 Zubehör. Weitere Varianten sind: 7 x 3 Bits 8 x 3 Bits 8 x 3 Bits plus dem Wera Handhalter “Rapid