Part Drawer modules

My 1st experience with designing a piece from nothing. I needed some drawers for my electronic parts so I made this.

I will make a module for the spools of wires a bit later

I tested this with Wood filament, PTEG, PLA

ABS will warp too much for the shelf part, I can probably make more holes to relief the stress.
but I don't need it myself

New:
-New drawer with compatible hook for DinRail (http://www.thingiverse.com/thing:1581801)
-Label holder on separators and increased gap of separator by 0.1mm

Previous changes:
- Is for the printers that are moving and shaking it too much, the middle supports can collapse.
-Will save about 100g of material over 3.1 at 100% infill.
-35% it is about 332g of PLA material instead of 376 @ 35% infill.
-I Print these at 10% total 310g
-Added some tabs to allow the back to stick better to the base
- Thicker, easier to remove and reuse separators


Notes:
-Scaling by 1000 may be needed, my units are mm in blender.
-New design