Thingiverse
Pasta Drying Rack
von Unipasserby97
10
Downloads
9
Likes
0
Makes
My shot at designing my own pasta drying rack. Inspired by the Marcato Pasta Drying Rack.
My design uses a 3/4" Wooden Dowel, for the main post, and a number of 3/8" Aluminum Rods, for holding the pasta, all bought from the local department store. May be subject to updates.
Standard M3 hardware used for assembly. Nylock nuts are used to fasten the legs. Printed in PETG for relative food safety, but should be fine as the printed parts shouldn't come into significant contact with food.
My design uses a 3/4" Wooden Dowel, for the main post, and a number of 3/8" Aluminum Rods, for holding the pasta, all bought from the local department store. May be subject to updates.
Standard M3 hardware used for assembly. Nylock nuts are used to fasten the legs. Printed in PETG for relative food safety, but should be fine as the printed parts shouldn't come into significant contact with food.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
