Pattern Holder - Instruction Stand

This is a stand for holding pattern instructions for sewing, quilting, models, or anything else you can think of. This was designed to hold a clip board or a thin instruction book in an easily viewable manner.

The primary style has holes and a very large arch cut through the back support. This can be printed without supports if your printer can handle crazy overhangs and bridging. Very good part cooling is essential for this to work well. For those whose printers may not be able to print the circle version without supports there is a second version with 45 degree angle slots that should be printable on any printer but will take a little longer to do so.

The front edge is rounded on the bottom to make it easier to pop off the bed when done printing. No post print clean up should be required.