Thingiverse
Pattern Shadow Candle Holder
door greeninja13
2
Downloads
1
Likes
0
Makes
Put candle in and light. Shadow from flame might make a cool pattern.
This will need supports and will probably require a resin printer.
Uniform scale as needed. Put things under candle as needed to get the right height for the shadow.
The bottom flat area is about 20mm (sorry I didn't really care to use human measurements while making this), so if your candle is 40mm in diameter, print at 200%
You can try it on an FDM printer, I did and woke up to spaghetti. Use "Print thin walls"
This will need supports and will probably require a resin printer.
Uniform scale as needed. Put things under candle as needed to get the right height for the shadow.
The bottom flat area is about 20mm (sorry I didn't really care to use human measurements while making this), so if your candle is 40mm in diameter, print at 200%
You can try it on an FDM printer, I did and woke up to spaghetti. Use "Print thin walls"
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
