PCB Assembler

This helps you to solder on your through-hole components to your PCB. (max ca. 80x100mm) Usage:Bend all the through-hole components, which you need to bend. Put all your through-hole components on your PCB. Put the PCB in to the PCB Assembler. Screw on the plywood with the sponges (right orientation). Don't screw it on too hard and not too loose. Turn the Assembler around and solder all the components to the PCBTake off the plywood with the sponges. How to make one:Print the modelInsert 4 M5x60 screws into the 4 Holes as shown on the pictures. Screw on 4 Hex Nuts. Put two Rubber Bands over the Screw and the sliding part in the middle, as shown on the pictures. Cut one of the two sponges into half. Glue the two sponges together with some superglue. Cut the plywood to the right size (same as the 3D-Print). Drill 4 Holes into the Plywood at the same positions, where the screws are. Stick the sponges onto the Plywood with some Double Sided Tape or glue. Use the Wing Nuts to screw on/of