PCB Holder 1.0 - Jeebo

This is a very simple and minimal pcb Holder.
Assembly is very simple. Only need a 5mm Allen wrench and phillips screwdriver.
Adjust the width by moving the bases along the axis/shaft
Adjust the orientation with two knobs.
With supports for soldering wires!!!
Maximun pcb: 170 x 220mm


Bill of material (BOM):
- Hexagonal Nuts M6 x2 un.
- Aluminiun, Steel o wood Shaft or similar Ø12.7mm x 250mm of large.
- Allen Bolt M6 x 30mm x2 un.
- Rubber or NBR rope of Ø5,5mm (5cm)
- bolt parker Ø3mm x 12mm (x4 un.)

See remix!!!!
https://www.thingiverse.com/thing:2830674