Thingiverse
PCB Workstation
by D4NNYDT2
8
Downloads
7
Likes
0
Makes
I wanted a PCB workstation and loved the XL by giufini but wanted something smaller. I took inspiration and the design of the articulating arms and made it so it would fit on my print bed in a single piece (200mm diameter).
I added Circle feet which allow rubber feet to be stuck on the bottom. These are added as parts so should be able to be removed in your chosen slicer if you use the .3mf (I used prusa slicer and could). I ahve added the .STL as the thing couldnt be published as .3mf cannot be the only file type
Photos to come later when its finished.
I added Circle feet which allow rubber feet to be stuck on the bottom. These are added as parts so should be able to be removed in your chosen slicer if you use the .3mf (I used prusa slicer and could). I ahve added the .STL as the thing couldnt be published as .3mf cannot be the only file type
Photos to come later when its finished.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!