PCBite Probe Holder Base

I LOVE my PCBite probes! There's just no place to safely put those super-sharp probe tips though!!

Why not put a probe holder on the base of the probe itself?

PRINT UPSIDE-DOWN for no-support printing.

I used Prusament PLA with a 0.25mm layer height.

NOTE: This is a fairly snug fit by design. If it's loose, it's harder to pick up and move.

If it's too tight for your bases, maybe scale by about 100.025% - 100.05% to add about 0.1mm to the diameter where the magnet fits. Remember: You don't want it loose.

TO REMOVE: Lay horizontally on solid flat surface. With one hand, pinch the gooseneck about 8mm from the holder and push straight towards the holder being held by the other hand.