Thingiverse
PCStand
von JKUgalde
3
Downloads
4
Likes
0
Makes
It is a foldable pc stand, the angle is adjusted using two knobs that press the axis tube to prevent rotation.
To assemble it, you require:
- 2 Front support
- 2 Knobs
- 2 ConectorA
- One of every other piece.
- 9.5 mm aluminium tubes. The length is custom, i used 2 of 200 mm, 2 of 150 mm and one of 110 mm to produce the stand in the photo.
The knobs needs M3 bolts and nuts. Every piece add the possibility to fasten with bolts trough a hole, but it is better to glue everything.
To assemble it, you require:
- 2 Front support
- 2 Knobs
- 2 ConectorA
- One of every other piece.
- 9.5 mm aluminium tubes. The length is custom, i used 2 of 200 mm, 2 of 150 mm and one of 110 mm to produce the stand in the photo.
The knobs needs M3 bolts and nuts. Every piece add the possibility to fasten with bolts trough a hole, but it is better to glue everything.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
