Thingiverse
Pegboard Hook
por Simple_Guy
4
Descargas
9
Likes
0
Makes
This is a 3D Printed Pegboard Hook! While it is only plastic, it is a very functional and useful print. I printed this with PLA, which was plenty strong. I'm sure if you were to print it with something like ABS or PLA+, you would have even better results. I made over ten prototypes of this hook before I released it on Makerworld, Printables, and Thingiverse. But here it is!
This hook has an angled edge at the bottom to ensure stability, when heavy objects are placed on it, as well as a thick curve to avoid the main area of pressure from snapping. Also, there is a small tab that sticks out of the middle to keep the hook in place. I would highly recommend that you use 100% Infill when you are printing, as it will use about three grams. It will last significantly longer than doing 15% or even 50% infill.
Please consider Liking and Following me on!
Makerworld: (https://makerworld.com/en/@simpleguy)!
Printables: (https://www.printables.com/@SimpleGuy_970984)!
Thingiverse: (http
This hook has an angled edge at the bottom to ensure stability, when heavy objects are placed on it, as well as a thick curve to avoid the main area of pressure from snapping. Also, there is a small tab that sticks out of the middle to keep the hook in place. I would highly recommend that you use 100% Infill when you are printing, as it will use about three grams. It will last significantly longer than doing 15% or even 50% infill.
Please consider Liking and Following me on!
Makerworld: (https://makerworld.com/en/@simpleguy)!
Printables: (https://www.printables.com/@SimpleGuy_970984)!
Thingiverse: (http
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
