Pendant Slide Ocarina

This is a funny little toy.So… this ocarina is not in a specific tune.It is loud and annoying.It is fun to play. How to use it:Close the slot with a finger of your right hand for the lowest note.Slide your chosen finger to the right to increase the pitch + blow a little bit harder.Don't block the soundhole on the back! I print them with:0.4 mm nozzle2 walls0.2 mm Layer hight4 Top and Bottom layersWall Ordering: Outside To Inside - Walls before Infill.20% Infill - Cross Hatch5mm BrimNo SupportImportantMake sure your bed adhesion is good, else it will fail, so… clean your bed before printing!Avoid stringingAvoid Z-Seam on the labiumHave fun!Boost MeYou want to support my work? Every Boost helps. You want more? Feel free to follow me :) MembershipJoin the commercial membership to sell physical prints of this model.Visit my Profile for more