Performance Piston

Hey Everyone!This is obviously another one for the Block Jocks! Its 4.125 in dia. with a .927 pin and 1.125 compression height. Drafting was honestly easier that manipulating the slicer to produce a smooth surface in the support areas without taking a week to print. I found a happy median i think. you can tell by the photos some of the under head support areas aren't as smooth as i would like but the visible outside looks pretty good. The rings are printed in place for convenience and the pin is 3 pieces for assembly purposes that fits together in the bore. Link to Connecting Rod.https://makerworld.com/en/models/2223567-performance-h-beam-connecting-rod#profileId-2418284Dimensions:4.125in Dia X 2.750in H Print Specifications:0.4 mm nozzle0.2 layer height2 wall loops15% infillsupports where needed Pin Assembly Instructions:The pictures show a good detail. Just put each pin half in the bore with the larger diameter pushed towards the outside from the center, If adding the rod option