Thingiverse
Peristaltic Pump
von Leland
180
Downloads
186
Likes
0
Makes
This is a Peristaltic Pump designed in Sketchup. I have tried to design it with an eye towards printing on a MakerBot, but do not own one so I cannot test at this time.
It should accept 3/4 inch hose with a 1/8 inch wall thickness.
It should accept 3/4 inch hose with a 1/8 inch wall thickness.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
