Slicer Discord
Pet Table – 3D-Druckmodell von MakerWorld MakerWorld
Pets

Pet Table

15 Downloads
8 Likes
9 Makes
Zum Modell
This is a set of interlocking pet tables I created for our cat, she's 13 and doesn't like bending down to her dish, so these raise them up a bit for her. There's two types one with a solid top and one with a hex grid on top, I would recommend the solid one as it's easier to clean. They are all 80mm high, the top of the square tables is 140mm x 140mm the corner table is 45 degree so 140mm on the side and about 88mm alon the back.
Kategorie
Pets
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen