Thingiverse
Phanteks Gpu Support
von kyle1087
29
Downloads
33
Likes
0
Makes
This is a gpu leveling bracket I made for my rx580 to go in my phanteks eclipse p400.
It slots into the vent holes on the power supply shroud and then props under it. It is set for 30mm gap from shroud to card as is.
It slots into the vent holes on the power supply shroud and then props under it. It is set for 30mm gap from shroud to card as is.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
