Phoenix

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can change X and Y but Z must remain the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 4.6mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.3 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 6 unique filaments. Substitute as needed. Swap Instructions: Start with Black At layer #9 (0.8mm) swap to Red At layer #14 (1.2mm) swap to Orange At layer #22 (1.84mm) swap to Yellow At layer #29 (2.4mm) swap to Black At layer #39 (3.2mm) swap to Blue Gray At layer #44 (3.6mm) swap to Jade White for the rest.