Phoenix

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 4.6mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.3PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Basic Orange Transmission Distance: 5PLA BambuLab Basic Yellow Transmission Distance: 6PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 6 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #9 (0.8mm) swap to RedAt layer #14 (1.2mm) swap to OrangeAt layer #22 (1.84mm) swap to YellowAt layer #29 (2.4mm) swap to BlackAt layer #39 (3.2mm) swap to Blue GrayAt layer #44 (3.6mm) swap to Jade White for the rest. Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial