Thingiverse
Phone Camera Protector
por dupsh
20
Descargas
8
Likes
0
Makes
THIS REQUIRES ASSEMBLY
This should greatly decrease the likelihood that your camera lens will be smudged when you go to take a picture. It does not add any increase or decrease in the amount of time that it takes to be ready to snap a photo, you can use your thumb to quickly open it in the same motion as pulling out your phone.
I use double-sided adhesive (cut with an X-Acto knife) to position it on the phone once the parts are carefully glued together making sure that the slider is not glued as well. *Only* install this after you have already installed a shatter-protection screen. Otherwise you would be gluing directly to your touchscreen. I use a little superglue as evenly as possible around the outside edges to further secure the protector to the phone's shatter-protection screen. It does not look bad once secured, and from a little distance it really looks fine.
You will need to double-check the measurements to make sure that it will not cover up the flash or sensors. Posi
This should greatly decrease the likelihood that your camera lens will be smudged when you go to take a picture. It does not add any increase or decrease in the amount of time that it takes to be ready to snap a photo, you can use your thumb to quickly open it in the same motion as pulling out your phone.
I use double-sided adhesive (cut with an X-Acto knife) to position it on the phone once the parts are carefully glued together making sure that the slider is not glued as well. *Only* install this after you have already installed a shatter-protection screen. Otherwise you would be gluing directly to your touchscreen. I use a little superglue as evenly as possible around the outside edges to further secure the protector to the phone's shatter-protection screen. It does not look bad once secured, and from a little distance it really looks fine.
You will need to double-check the measurements to make sure that it will not cover up the flash or sensors. Posi
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
