Phone Stand -> Simple. Practical. Sturdy.

This is a really sturdy, simple phone stand that can be printed on its side on any printer. It should fit all phones but if you're really worried you have a thick case or phone just check if it's within 12mm thick, it will fit things slightly thicker than that too! The phone in the pictures is the iPhone 16 Pro Max so it's no problem for the bigger phones and doesn't tip over too easy, also works amazingly with the smaller phones!

The print can be done with 0% infill and 3 wall loops being plenty strong enough. You can also crank up the speed as it should be sliced as mostly just building a wall up. The quality is really good with those higher speeds because it's just a lot of simple walls!

I designed it in OnShape and it only took a few prototypes to get it looking and feeling good. This model will be a good bit stronger than most of the others out there as it is one solid piece and won't have your phone too precariously angled. If you have any feedback please let me know as I real