Thingiverse
Phone Stand
von PsychicM
4
Downloads
3
Likes
0
Makes
Just a small phone stand i made which can hold even large phones vertically without toppling.
Need support under the base but that is all, if your printer can bridge well you might even get away with no supports. Has a gap for a charging cable at the bottom
Need support under the base but that is all, if your printer can bridge well you might even get away with no supports. Has a gap for a charging cable at the bottom
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
