Thingiverse
Pi 2-3 Case light
von Simatics
1
Downloads
0
Likes
2
Makes
A simpel Raspberry Pi 2 or 3 Case.
- The Boddy need 17g Filament.
- The Top need less then 10g Filament.
- The Card Cover need less then 1g
Logo ist very small at right site.
also you need min. 2 M3x6mm Screws to screw down the pi in the Case.
- The Boddy need 17g Filament.
- The Top need less then 10g Filament.
- The Card Cover need less then 1g
Logo ist very small at right site.
also you need min. 2 M3x6mm Screws to screw down the pi in the Case.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
