Pi b+ Case with Partial Camera Case

I remixed a few things into 1 thing, basically a raspberry pi b+ case, with a camera case for an altered camera. I altered the raspberry pi camera by removing the lens and then using this m12 mount for v2 camera here https://www.thingiverse.com/thing:3347061 and the back plate from here https://www.thingiverse.com/thing:2307685 was remixed to be able to be used with the arm from https://www.thingiverse.com/thing:3747437.

Then I mixed in the pi b+ case from this thing https://www.thingiverse.com/thing:967847 to also be able to have an arm attached to it. The result is this design.

The camera back was a difficult print, and I printed it with supports only touching build plate. The part that connects to the arm was the bottom for the print. It was delecate to separate the supports from the part.

I created bolts from this thing https://www.thingiverse.com/thing:193647 the threadlength is a little longer than needed but can be clipped off, in the end I bought bolts for it in