Thingiverse
Pi Camera mount
por stmorgan
7
Descargas
1
Likes
0
Makes
A forward facing Pi camera mount. Snaps together with no fasteners, provides 4 3.6mm holes, sized for #6 sheetmetal screws.
The lens hole should be 2.5mm below the centerline of the part if you want to use it in a design. The screw holes are 23mm on center horizontally and 35mm on center vertically, the lens is 15mm up from the centerline of the lower screw holes, centered horizontally.
Final Update: The MKV version is the final iteration. I deem it perfect for my use. Other designs are sub-par. Leaving up for posterity, but the MKV is the one you want. Download PiCamMountMKV and PiCamMountMKVTop. These are what you want. Normal old PLA, print the top standing vertically with supports, resist the urge to lay it flat, the hooks will break at layer lines.
The lens hole should be 2.5mm below the centerline of the part if you want to use it in a design. The screw holes are 23mm on center horizontally and 35mm on center vertically, the lens is 15mm up from the centerline of the lower screw holes, centered horizontally.
Final Update: The MKV version is the final iteration. I deem it perfect for my use. Other designs are sub-par. Leaving up for posterity, but the MKV is the one you want. Download PiCamMountMKV and PiCamMountMKVTop. These are what you want. Normal old PLA, print the top standing vertically with supports, resist the urge to lay it flat, the hooks will break at layer lines.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!