Thingiverse
pi-like-stack
2
Downloads
2
Likes
0
Makes
# pi-like-stack
Yet another way to stack pi-like or other SBCs (single board computers) on top of one another.
**For a standard 40pin raspberry pi A/B or similar board you probably want ``full.stl``**
https://github.com/BreadMakesYouFull/pi-like-stack
The default board size is for 40-pin like A/B model mainline pi-like devices.
85mm x 56mm x 20mm, with standoffs 2.5mm diameter.
Each layer is 100mm x 75mm.
Printed without-support at 60% infill (PLA)
## Requires
* Openscad (or use the pre-made STLs)
## Quickstart
```
openscad ./pi_like_stack.scad
```
## LICENSE
openscad file & project - MIT : pi_like_stack_scad_MIT.txt
STL files - CC BY-SA 4.0 : stls.txt
Yet another way to stack pi-like or other SBCs (single board computers) on top of one another.
**For a standard 40pin raspberry pi A/B or similar board you probably want ``full.stl``**
https://github.com/BreadMakesYouFull/pi-like-stack
The default board size is for 40-pin like A/B model mainline pi-like devices.
85mm x 56mm x 20mm, with standoffs 2.5mm diameter.
Each layer is 100mm x 75mm.
Printed without-support at 60% infill (PLA)
## Requires
* Openscad (or use the pre-made STLs)
## Quickstart
```
openscad ./pi_like_stack.scad
```
## LICENSE
openscad file & project - MIT : pi_like_stack_scad_MIT.txt
STL files - CC BY-SA 4.0 : stls.txt
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
