Thingiverse
pi mount
von ProjectPaatt
0
Downloads
0
Likes
0
Makes
only exposes 1 usb, net, sdcard, power
mounts to a surface that has the same raspberry pi mounts / spacing holes
cover pinches board onto the base, don't need to screw the rpi onto the base.
holes for ventalation
TODO:
* make net exposure hole a little tighter to make the seperater with the USB ports a little tougher. (use super glue to strengthen for now)
* make the cover screw hole on the base plate bigger (use a drill for now)
mounts to a surface that has the same raspberry pi mounts / spacing holes
cover pinches board onto the base, don't need to screw the rpi onto the base.
holes for ventalation
TODO:
* make net exposure hole a little tighter to make the seperater with the USB ports a little tougher. (use super glue to strengthen for now)
* make the cover screw hole on the base plate bigger (use a drill for now)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!