Pi TFT50 printed standoffs

I wanted to use the case design by RuiRaptor for my Pi TFT50. However I did not have any 2.5mm standoffs around the house. So I just spent a few minutes and designed a spacer to work in place of the standoffs.

The design uses the original 2.5mm screws from the TFT50 kit and then you can use any 3mm screw or plastic screw from there to attach it to the back of the case. I used the precision screwdriver from my stepper drivers to slide all the way through the spacer and screw in the 2.5 mm screws.

Thanks to RuiRaptor for the nice case design! If you haven't seen his video here is the link to it:
https://www.youtube.com/watch?v=1rDB5PI7r-0&feature=emb_logo

You can get the files from his Patreon page for free as well!!

https://www.patreon.com/posts/bigtreetech-pi-41510619