Thingiverse
Pi Zero & Camera Case
di MiniSumo
11
Download
6
Likes
0
Makes
This was aimed at hanging on the back wall of our Birdbox, the Raspberry Pi Zero W is loaded up with MotionEyeOS for simple survelance of the nesting box.
This fits one of the standard nigth vision camera modules but, to manage space and size, only one of the IR lamps is fitted.
I've used 6 M2.5 Socket Head Cap Screws, 2 @ 20mm long and 4 @ 10mm.
1 x 10mm to add strength to the 8mm thread that allows angle adjutment
1 x 10mm camera case lid to body
2 x 10mm Pi Case Lid to Body and board mounting
2 x 20mm Camera Mount, though lid, case and Pi
Ribbon from the Pi is folded under the board and through 90 degrees to pass out through the slot and into the camera case.
The camera is simply pushed into place and retained by the lid.
USB Power entry on the bottom left and an eye on the rear for screw mounting to the wall.
This fits one of the standard nigth vision camera modules but, to manage space and size, only one of the IR lamps is fitted.
I've used 6 M2.5 Socket Head Cap Screws, 2 @ 20mm long and 4 @ 10mm.
1 x 10mm to add strength to the 8mm thread that allows angle adjutment
1 x 10mm camera case lid to body
2 x 10mm Pi Case Lid to Body and board mounting
2 x 20mm Camera Mount, though lid, case and Pi
Ribbon from the Pi is folded under the board and through 90 degrees to pass out through the slot and into the camera case.
The camera is simply pushed into place and retained by the lid.
USB Power entry on the bottom left and an eye on the rear for screw mounting to the wall.
MiniSumo pubblica anche su
35 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
