Thingiverse
Electronics
Model downloaden
Pi ZERO case
44
Downloads
40
Likes
0
Makes
This is my home-bridge case for my pi zero. There is a slot for the 433MHz transmitter. I recommend using a glue gun to stick down the transmitter. If you are using a DHT22 sensor make sure that one is out the case where the usb cable comes out. works perfectly and looks nice on the desk.
Also you will need to cut out the plastic that is covering the cable output.
Also you will need to cut out the plastic that is covering the cable output.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
