Thingiverse
Pi3 Case
von Michaelo
20
Downloads
5
Likes
0
Makes
Cases for the Raspberry Pi (based on other designers and my own)
First a copy Steve's Case with different mounting... not complete...
The side rails should be printed separately otherwise you won't be able to slide in the PI (unless you cut the left part)... will add rails later after I print this...
The back piece needs work, again I need to print it and check size...
**Notes:**
If designs are identified as a **"Work In Progress"**, that normally means I have not printed a copy to test everything, so don't download and print as there will be errors and probably a lot of sanding....
Just to mention again, this design is a copy of *Steve's Case* https://www.thingiverse.com/thing:684495
First a copy Steve's Case with different mounting... not complete...
The side rails should be printed separately otherwise you won't be able to slide in the PI (unless you cut the left part)... will add rails later after I print this...
The back piece needs work, again I need to print it and check size...
**Notes:**
If designs are identified as a **"Work In Progress"**, that normally means I have not printed a copy to test everything, so don't download and print as there will be errors and probably a lot of sanding....
Just to mention again, this design is a copy of *Steve's Case* https://www.thingiverse.com/thing:684495
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!