Thingiverse
PiCam3A
von tropho
1
Downloads
0
Likes
0
Makes
Camera case for a Raspberry Pi 3A+
The "front" piece is designed to fit a Raspberry Pi camera with a motorized IR cut filter (to switch between day and night vision modes automatically) and wide angle lens. Search for "IR cut raspberry pi camera" on Amazon to find various models.
The "back" piece has a port exposed for the 3A+'s single USB port, for using a USB microphone for capturing audio.
The front/lid must be glued to seal everything up, and if the camera will be used outdoors I recommend adding some marine-grade silicone sealant around the edges of each piece to make it watertight. I've used my Pi cameras outdoors for years at a time without moisture getting into the case, though they have been mounted under the edge of a roof and not directly under rain.
Support are not required.
The "front" piece is designed to fit a Raspberry Pi camera with a motorized IR cut filter (to switch between day and night vision modes automatically) and wide angle lens. Search for "IR cut raspberry pi camera" on Amazon to find various models.
The "back" piece has a port exposed for the 3A+'s single USB port, for using a USB microphone for capturing audio.
The front/lid must be glued to seal everything up, and if the camera will be used outdoors I recommend adding some marine-grade silicone sealant around the edges of each piece to make it watertight. I've used my Pi cameras outdoors for years at a time without moisture getting into the case, though they have been mounted under the edge of a roof and not directly under rain.
Support are not required.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
