Thingiverse
PiCam3A
di tropho
1
Download
0
Likes
0
Makes
Camera case for a Raspberry Pi 3A+
The "front" piece is designed to fit a Raspberry Pi camera with a motorized IR cut filter (to switch between day and night vision modes automatically) and wide angle lens. Search for "IR cut raspberry pi camera" on Amazon to find various models.
The "back" piece has a port exposed for the 3A+'s single USB port, for using a USB microphone for capturing audio.
The front/lid must be glued to seal everything up, and if the camera will be used outdoors I recommend adding some marine-grade silicone sealant around the edges of each piece to make it watertight. I've used my Pi cameras outdoors for years at a time without moisture getting into the case, though they have been mounted under the edge of a roof and not directly under rain.
Support are not required.
The "front" piece is designed to fit a Raspberry Pi camera with a motorized IR cut filter (to switch between day and night vision modes automatically) and wide angle lens. Search for "IR cut raspberry pi camera" on Amazon to find various models.
The "back" piece has a port exposed for the 3A+'s single USB port, for using a USB microphone for capturing audio.
The front/lid must be glued to seal everything up, and if the camera will be used outdoors I recommend adding some marine-grade silicone sealant around the edges of each piece to make it watertight. I've used my Pi cameras outdoors for years at a time without moisture getting into the case, though they have been mounted under the edge of a roof and not directly under rain.
Support are not required.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
