Thingiverse
PICKit3 StrongBox
von freshnelly
2
Downloads
0
Likes
0
Makes
I was tired of breaking these boards with the crappy case the PICKit3 comes inside of (mostly the USB end) so I designed this case. Also the GREEN LED will shine through the "Not Red" bezel (Idiots!) which I had never seen before!
If you don't want to print this with transparent PLA, just drill the LED holes after.
The field programming button is accessible, and soldering a male pin header to exit via the slot on top has also been useful.
If you don't want to print this with transparent PLA, just drill the LED holes after.
The field programming button is accessible, and soldering a male pin header to exit via the slot on top has also been useful.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!