Thingiverse
Picture frame
von Jam007
109
Downloads
152
Likes
0
Makes
This simple frame is ideal to fill empty walls with pictures and photos. It is designed to be used with plexiglass of size 18x13cm, for my purpose it had thickness 0.75mm but other size should fit too.
There are two holes for nail so frame can be placed vertical or horizontal.
To hold plexi and picture inside press clips and match them into holding holes.
Place frame on printing table as you look at it at wall, use support for smooth surface inside due to matching of plexi.
You need:
Frame x1
Frame clips x16
Plexiglass size 18x13mm
You can hang your picture without it too.
I hope you would like your arts at walls :).
There are two holes for nail so frame can be placed vertical or horizontal.
To hold plexi and picture inside press clips and match them into holding holes.
Place frame on printing table as you look at it at wall, use support for smooth surface inside due to matching of plexi.
You need:
Frame x1
Frame clips x16
Plexiglass size 18x13mm
You can hang your picture without it too.
I hope you would like your arts at walls :).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
