PiGRRL Zero Screen Bezel

Like many people, I was quick to rush and build a PiGrrl Zero when Adafruit first introduced the design. After I completed the build, I noticed a pretty wide gap between the inside of the top faceplate and the LCD screen. This was not a major issue at first, but over time and usage, minor bits of dirt were able to get inside, as well as the screen came loose from the double-sided tape causing the screen to flop around inside.

I remember searching around to see if others had had the same issue. I don't remember where I saw it,but someone had mentioned on a message board somewhere where they had used something as a spacer between the two. I know it wasn't something 3D printed, but I know I don't take full credit for the idea of a spacer either. I held off on doing anything at that point in time though.

Then I came across Jpete24's design and decided I'd like to try again with one that had its own sound source and volume knob. After I printed the parts (version 3 for me), I im