pikachu mouse

hello i made this because i wanted a pikachu mouse and if you guys like it i may make more instructions step 1place the clear part as shown in the pic and put the black part in with the clip facing up step 2put the wheel on the joint and place in the bace as shown hold the board down and make sure the black clip is attached to the power switch step 3put the red wire in with the solder joint facing down and make sure to press the clips in so it can fit in then put the black wire in with the solder facing up and agan press the clips so it can fit in this step is a bit difficult step 4 place the cover over the board step 5plug in the power cable and scew in the support scew step 6 place a AA battery in and turn it on to make sure it is working turn off if it is working step 7</