Thingiverse
Pillar Statue
von mechadense
42
Downloads
34
Likes
2
Makes
My first try to scan with photos and 123D Catch.
I guess this thing is supposed to be used for a flower pot but it was used for a table here. The original was about very roughly 80cm high.
The BY-NC-SA license is enforced by Autodesk. See here:
http://sitesupport.123dapp.com/entries/20059427
under 3. Your content (ii)
Interesting fact:
In the tutorial videos there where three resolutions to choose from but I could choose only from two. I hope they didn't remove the highest resolution option.
If anyone knows details please comment.
I guess this thing is supposed to be used for a flower pot but it was used for a table here. The original was about very roughly 80cm high.
The BY-NC-SA license is enforced by Autodesk. See here:
http://sitesupport.123dapp.com/entries/20059427
under 3. Your content (ii)
Interesting fact:
In the tutorial videos there where three resolutions to choose from but I could choose only from two. I hope they didn't remove the highest resolution option.
If anyone knows details please comment.
mechadense veröffentlicht auch auf
68 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!