Thingiverse
Pipe clamp
von les_kaye
124
Downloads
75
Likes
0
Makes
Pipe Clamp
========
Clamp for 70mm (2 3/4 inch) outside diameter pipe or scale to requirements.
Requires M5 x 25mm (or longer) hex bolt and nut or Imperial size equivalent.
Cut the end of the pipe as shown about 65mm (2.5 inches) to allow it to compress.
This is best printed in ABS or PETG if it is to be used outside.
========
Clamp for 70mm (2 3/4 inch) outside diameter pipe or scale to requirements.
Requires M5 x 25mm (or longer) hex bolt and nut or Imperial size equivalent.
Cut the end of the pipe as shown about 65mm (2.5 inches) to allow it to compress.
This is best printed in ABS or PETG if it is to be used outside.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!