Pipe Flow Analysis

In this simulation a channel's cross section was analyzed, 5 NPS 1/8 SCH 40 pipes were used to cool down stationery water in a larger channel, flow was analyzed for 10s (more CPU time for longer calculation on my CPU). Ambient Temperature: 313.15 K Initial Pipe (all 5 pipes) Temperature: 313.15 K Water Temperature: 281.15 K Water Flow Rate (Pipes): 0.00015 m^3/s (9 lt./min) Water Flow Rate (Channel): 0 m^3/s Material of the Pipes: Steel Stainless 302 (Pre-Defined\Alloys) Gravity: On Coarse Mesh (3/8 Level) As soon as the flow started, the pipes and water (stationery) started to cool down, as you can see from the temperature graphics attached (all photos are after 10 s of flow). It will take a large amount of CPU power and time to calculate time for water (stationery) and all the 5 pipes to be at same temperature as cold water. This simulation took my CPU 2 and a 1/2 hours to complete. Temperature Animations: http://www.dailymotion.com/video/x2ngs20_pipe-flow-analysis-temperature-changes_school